Applicability economy of casting materials for EPC manufacturers

Applicability to casting materials

Generally speaking, any alloy that can be cast in shaft sleeve casting factory can be cast by EPC, which is more adaptable than sand casting. The casting of titanium alloy can be done by traditional sand mold, but EPC can meet the demand of titanium alloy. Now many parts with different texture can be produced by EPC process. Typical materials include gray cast iron, stainless steel, carbon steel, ductile iron non-ferrous alloy, etc.

Suitability for casting size

There are some factors that affect the size of the casting the number of castings in a sand box. Among them, the size of the use area of the vibrating table the size of the sand box of the pouring system. Because of the advantages of the lost foam casting process, compared with the traditional casting, the applicability of the lost foam casting is much wider. It can be used in the same sand Different casting patterns are arranged in the box to make the casting inclusive. At the same time, it can be used to cast small-sized parts large-sized parts. The production of large-sized parts depends on the capacity of smelting medium frequency furnace. The arrangement of small-sized parts is flexible flexible according to the size of sand box.

Applicability to various structures of castings

It is very difficult to choose the parting surface the parts which are difficult to form. The technology of EPC can meet the needs that traditional casting can meet.

Such parts include cylinder block, pump impeller, propeller, etc.

It can be produced either individually on a large scale

Lost foam production requires a lot of EPS plastic foam. Therefore, the cost will be increased in mass production. For a small number of production, manual cutting glue can be used to synthesize the casting parts, the applicability of the mould can be flexible due to the large number of white moulds manufactured by manual foam molding.

Quality advantage of EPC Casting

It can be seen the production process that the EPC process is similar to the paraffin precision casting, the casting process is similar to the V-process casting, the molding process is similar to the solid casting. Therefore, Modern EPC technology combines the advantages of solid mold, v-mold precision casting.

EPC is easy to realize clean production

EPC adopts negative pressure method, which is conducive to the collection centralized treatment of emissions gases, the used sand can be reused, so it is a win-win situation for production environment.